Make sure you have a bushing placed inside the center hole of the side plate that the main pulley fits into. Where are the slotted wheel bushings? Remove the 4 loose screws from inside the body. The machine I am working on may be slightly different from your own. At this point you can toss your old belts and bushings.
Complete guide to replacing drive belts in a robotic pool cleaner with pictures. If you haven't had them replaced in at least 2 seasons of use, they are How to assemble the various parts of a drive system prior to installation on an aquabot.
Aquabot Parts and Repair, changing loose or broken drive belts. These Aquabot Parts must be installed correctly or the belts won't work properly. Take your.
Aquabot Parts and Repair. Changing the Drive Belt
How to Replace an Aquabot Classic Robotic Pool Cleaner Drive Belts BUY PARTS - If you need to replace one Drive Belt, you should replace the pair of Make sure three bushings haven't dropped out and the plastic washers are in place.
Create an account Forgot Password? Video is about 8 minutes. Turn the Aquabot upside down. These parts wear down causing slack in the belts causing them to slip.
You can take a quick look under the drive track to check on their condition.
BIGDONSBOYS HAND STAND
|NOTE: The bushings are mounted on the sideplate.
To test your work, grab each wheel tube and turn by hand.
Email Address: Promotion Codes. Remove the 4 loose screws from inside the body. Another bushing can be placed in the opening on the body of the unit directly in the center.
Aquabot Turbo T2 Parts
Aquabot Belt Replacement Replacing your belts is easy. NOTE: ALWAYS DISCONNECT THE POWER BEFORE SERVICING YOUR. Aqua Products Cleaner Replacement Parts. Aquabot Aquabot Turbo T Robotic Pool Cleaner Parts. NLA-Replace with SKMS01, NLA, No Longer Available.
Replacement parts for Aquabot Turbo T-Jet. $ Aquabot Turbo T-Jet - Replacement Parts. Axle, Oval Tube, Switching Wedge, Blue - ASPK. Quantity.
Use your flat head screwdriver to carefully pop them off.
At this point you can toss your old belts and bushings. Email Address:. Next remove the two retaining clips on the end of the wheel tubes.
Video: Changing the aquabot turbo t parts Aquabot Turbo T Jet Quick Start Video Guide
Password: Remember Me. The belt will be riding on the fat end and is very important for proper tension of the drive belts.
Sometimes. Aquabot Replacement Parts - common parts for Aquabot pool cleaners - tracks, brushes, belts, bags and more from Aquabot Turbo T Jet Robotic Pool Cleaner.
On units with two pairs of belts 2 motors you will need 8 total bushings. Best practice: change the 3 sideplate bushings and the drive bushing that rests in the robot body supporting the drive gear, for a total 4 bushings and the 2 stepped rollers.
Next remove the two retaining clips on the end of the wheel tubes. Remove the bottom plate and the filter bag. Unfortunately the newer style side plate and drive tracks are a bit tougher to work with, and the drive track must remain installed the entire time.
It will also give you a better understanding of how the drive system operates and gives you the knowledge to possibly diagnose issues with movement. To test your work, grab each wheel tube and turn by hand.